Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION SENSOR (for Power Seat)

(a) Check that the engine switch is off.

(b) Check that the negative battery (-) terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Using a feeler gauge 1 mm (0.039 in.), install the seat position sensor.

NOTICE:
* If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
* When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
HINT
Be sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).

(d) Using a "torx" socket wrench (T30), tighten the "torx" screw to install the seat position sensor.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Make sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to1.4 mm (0.055 in.).

(f) Check that there is no looseness in the installation parts of the seat position sensor.

(g) Connect the connector.

(h) Install the seat slide position sensor protector to the seat position sensor.

3. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)

for Standard type: Installation

for Sports type: Installation

4. INSTALL FRONT REAR INNER SEAT TRACK COVER LH (for Power Seat)

for Standard type: Installation

for Sports type: Installation

5. INSTALL FRONT REAR OUTER SEAT TRACK COVER LH (for Power Seat)

for Standard type: Installation

for Sports type: Installation

6. INSTALL FRONT INNER SEAT TRACK COVER LH (for Power Seat)

for Standard type: Installation

for Sports type: Installation

7. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Power Seat)

for Standard type: Installation

for Sports type: Installation

8. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat) Reassembly

9. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat) Reassembly

10. INSTALL VERTICAL ADJUSTING HANDLE (for Manual Seat) Reassembly

11. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat) Reassembly

12. INSTALL VERTICAL SEAT ADJUSTER KNOB (for Manual Seat)

13. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) Installation

14. INSTALL REAR INNER SEAT TRACK BRACKET COVER (for Manual Seat) Installation

15. INSTALL REAR OUTER SEAT TRACK BRACKET COVER (for Manual Seat) Installation

16. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER (for Manual Seat) Installation

17. INSTALL FRONT INNER SEAT TRACK BRACKET COVER (for Manual Seat) Installation

18. INSTALL FRONT SEAT HEADREST ASSEMBLY

19. CONNECT BATTERY NEGATIVE TERMINAL (for Manual Seat)

20. INSPECT FRONT SEAT ASSEMBLY (for Power Seat) Installation

21. INSPECT FRONT SEAT ADJUSTER ASSEMBLY (for Manual Seat)

22. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.