Removal

2GR-FSE EXHAUST: EXHAUST PIPE: REMOVAL

CAUTION:
* Wear protective gloves when removing the exhaust pipe.
* The exhaust pipe is extremely hot immediately after the engine has stopped.
* Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE NO. 1 FLOOR UNDER COVER

(a) Remove the 5 clips and No. 1 floor under cover.





2. REMOVE NO. 2 FLOOR UNDER COVER

(a) Remove the 6 clips and No. 2 floor under cover.





3. REMOVE REAR NO. 1 FLOOR PANEL BRACE

(a) Remove the 4 bolts and rear No. 1 floor panel brace.





4. REMOVE FRONT CENTER FLOOR BRACE

(a) Remove the 4 bolts and front center floor brace.





5. DISCONNECT HEATED OXYGEN SENSOR

(a) Remove the grommets of the heated oxygen sensors.





(b) Using SST, remove the heated oxygen sensors (BANK 1, BANK 2).





SST : 09224-00010

6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the 4 bolts and 4 nuts.





(b) Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.





(c) Remove the front exhaust pipe assembly and 3 gaskets.

7. REMOVE TAIL EXHAUST PIPE ASSEMBLY

(a) Disconnect the 6 exhaust pipe supports to remove the tail exhaust pipe assembly.





8. REMOVE EXHAUST PIPE DAMPER

(a) Remove the 2 bolts and exhaust pipe damper.





9. REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY

(a) Using a plastic hammer, uniformly tap off the tail exhaust pipe baffle sub-assembly.