Identification of Noise Source

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM (w/o Multi-display): IDENTIFICATION OF NOISE SOURCE

1. RADIO WAVE BAND

(a) Radio frequency band

(1) Radio broadcasts use the radio frequency bands shown in the table below.





2. SERVICE AREA





(a) The broadcast range for AM and FM is very different. Sometimes an AM broadcast can be received very clearly but FM stereo cannot.

FM stereo has the smallest service area, and is prone to picking up static and other types of interference (for example, noise).

3. RECEPTION PROBLEMS

HINT
Besides the problem of static, there are other problems, such as "phasing", "multipath" and "fade out". These problems are caused by the nature of the radio waves themselves, not by electrical noise.





(a) AM broadcasts are susceptible to electrical interference called phasing. Occurring only at night, phasing is the interference created when a vehicle receives 2 radio wave signals from the same transmitter. One signal is reflected off of the ionosphere and the other signal is received directly from the transmitter.





(b) Multipath is a type of interference created when a vehicle receives 2 radio wave signals from the same transmitter. One signal is reflected off of buildings or mountains and the other signal is received directly from the transmitter.





(c) Fade out is caused by objects (buildings, mountains, etc.) that deflect away part of a signal, resulting in a weaker signal when the object is between the transmitter and vehicle. High frequency radio waves, such as FM broadcasts, are easily deflected by obstructions. Low frequency radio waves, such as AM broadcasts, are much more difficult to deflect.

4. NOISE PROBLEMS

(a) Technicians must have a clear understanding about the noise problems of the customer's vehicle. Use the following table to diagnose the problems.





HINT
When the noise does not match the examples above, refer to "Reception Problems". Check the descriptions about phasing and multipath.