Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System:
* After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH Disassembly

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE FRONT UPPER ARMREST BASE PANEL Disassembly

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY Removal

7. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly

8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

9. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly

10. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and motor.





NOTICE:
Be careful when removing the screws as the motor may fall and become damaged.