Removal
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL
1. PRECAUTION
NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Service Precautions.
2. REMOVE REAR NO. 2 FLOOR BOARD Removal
3. REMOVE REAR DECK FLOOR BOX Removal
4. REMOVE REAR NO. 3 FLOOR BOARD Removal
5. REMOVE DECK FLOOR BOX RH Removal
6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE Removal
7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
8. REMOVE FRONT DOOR SCUFF PLATE Removal
9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY Removal
10. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP Removal
11. REMOVE REAR DOOR SCUFF PLATE Removal
12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP Removal
13. REMOVE LAP BELT OUTER ANCHOR COVER
(a) Disengage the 3 claws and remove the lap belt outer anchor cover.
14. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
15. REMOVE CENTER PILLAR LOWER GARNISH Removal
16. REMOVE CENTER PILLAR UPPER GARNISH Removal
17. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
(a) Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
(b) Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
Text in Illustration
HINT
Tape the screwdriver tip before use.
(c) Disconnect the connector.
(d) w/ Pre-collision System:
(1) Disconnect the connector.
(e) Remove the 2 bolts and front seat outer belt assembly.
18. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Remove the 2 bolts.
(b) Disengage the guide and remove the front shoulder belt anchor adjuster assembly.