Dynamic Radar Cruise Control System

CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P0500: Vehicle Speed Sensor Malfunction
P0500 - Vehicle Speed Sensor Malfunction

DESCRIPTION

Refer to DTC P0500 for SFI system P0500.





WIRING DIAGRAM

Refer to DTC P0500 for SFI system P0500.

INSPECTION PROCEDURE

This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.

PROCEDURE

1. READ OUTPUT DTC (DTC P0500)

(a) Clear the DTCs Dynamic Radar Cruise Control System.

(b) Perform the following to make sure that the DTC detection conditions are met.

HINT
If the detection conditions are not met, the malfunction cannot be detected.

(1) With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).

(c) Read the DTCs Dynamic Radar Cruise Control System.

OK:

DTC is not output.

NG -- GO TO SFI SYSTEM P0500

OK -- USE SIMULATION METHOD TO CHECK Electronic Circuit Inspection Procedure