Installation

2GR-FSE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION

1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)

(a) Install the sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the sensor connector.

2. INSTALL VVT SENSOR (for Intake Side of Bank 2)

(a) Install the sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the sensor connector.

3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)

(a) Install the sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the sensor connector.

4. INSTALL VVT SENSOR (for Intake Side of Bank 1)

(a) Install the sensor with the bolt.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the sensor connector.

5. INSTALL V-BANK COVER Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.