Pre-Collision System (w/ Driver Monitor Camera)

PRE-COLLISION: PRE-COLLISION SYSTEM (w/ Driver Monitor Camera): U1119,U1119,U1120: Lost Communication with Object Recognition ECU (CAN)
U1120 - Lost Communication with Object Recognition Camera

DESCRIPTION

The driving support ECU uses the front millimeter wave radar sensor, driver monitor camera and object recognition camera sensor to detect obstacles in front of and behind the vehicle, and detect the direction that the driver's head is facing. Based on this information, the driving support ECU sends pre-collision control operation signals.

When a serial communication stop between the object recognition ECU and object recognition camera sensor is detected, DTCs U1119 and U1120 are output.

When a CAN communication stop between the object recognition ECU and driving support ECU is detected, DTC U1119 is output.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (OBJECT RECOGNITION ECU)

(a) Enter the following menus: Powertrain / Radar Cruise / Data List.

(b) Check the condition of the "Communication with Object Recognition ECU" Data List item.

HINT
As the "Communication with object recognition ECU" item monitors the CAN communication condition, distinguishing between a CAN communication malfunction and serial communication malfunction is possible. If a CAN communication malfunction may be present, proceed to the DIAGNOSTIC TROUBLE CODE CHART.

Result





B -- GO TO CAN COMMUNICATION SYSTEM Diagnosis System
A -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (OBJECT RECOGNITION ECU - OBJECT RECOGNITION CAMERA SENSOR)





(a) Disconnect the g1 ECU connector.

(b) Disconnect the X18 camera sensor connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. REPLACE OBJECT RECOGNITION CAMERA SENSOR

(a) Replace the object recognition camera sensor Removal.

NEXT -- Continue to next step.

4. ADJUST OBJECT RECOGNITION CAMERA SENSOR

(a) Adjust the object recognition camera sensor Adjustments.

NEXT -- Continue to next step.

5. CHECK OBJECT RECOGNITION ECU

(a) Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Code.

(b) Select "Clear" and clear the data.

(c) Based on the DTC detection conditions, try to simulate the malfunction.

(d) Recheck for DTCs.

OK:

DTC U1119 and U1120 are not output.

NG -- REPLACE OBJECT RECOGNITION ECU

OK -- END

6. REPLACE OBJECT RECOGNITION ECU

(a) Replace the object recognition ECU Removal.

NEXT -- Continue to next step.

7. ADJUST OBJECT RECOGNITION CAMERA SENSOR

(a) Adjust the object recognition camera sensor Adjustments.

NEXT -- Continue to next step.

8. CHECK DRIVING SUPPORT ECU

(a) Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Code.

(b) Select "Clear" and clear the data.

(c) Based on the DTC detection conditions, try to simulate the malfunction.

(d) Recheck for DTCs.

OK:

DTC U1119 and U1120 are not output.

NG -- REPLACE DRIVING SUPPORT ECU Removal

OK -- END