P0C76

HYBRID / BATTERY CONTROL: HYBRID CONTROL SYSTEM: P0C76-523: Hybrid Battery System Discharge Time Too Long
P0C76-523 - Hybrid Battery System Discharge Time Too Long

DESCRIPTION

Refer to the description for DTC P0A78-266 P0A78.





HINT
When the power switch is turned off, the MG ECU applies current to MG2 in a way that does not generate torque, in order to discharge the residual voltage in the inverter. When the hybrid system is normal, the VH value is almost 0 V after discharge. This DTC will be stored if the VH value is more than the specified value after discharge.





INSPECTION PROCEDURE

PROCEDURE

1. CHECK DTC OUTPUT (HV)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

(d) Check if DTCs are output.

Result:









HINT
- *1: If any INF codes are output for this DTC, refer to the corresponding diagnostic procedure.
- P0C76-523 may be output due to a malfunction which causes the DTCs in the table above to be output. In this case, first troubleshoot the output DTCs in the table above. Then, perform a reproduction test to check that no DTCs are output.

(e) Turn the power switch off.

B -- GO TO DTC CHART Hybrid Control System

A -- REPLACE INVERTER WITH CONVERTER ASSEMBLY Components