Installation

AUDIO / VISUAL: NETWORK GATEWAY ECU: INSTALLATION

1. INSTALL NETWORK GATEWAY ECU

(a) Install the network gateway ECU with the nut.





(b) Connect the connector.





(c) Install the certification ECU with instrument panel wire with the bolt and 2 nuts.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

2. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

3. INSTALL LOWER INSTRUMENT PANEL RH Installation

4. INSTALL SIDE INSTRUMENT PANEL RH Installation

5. INSTALL FRONT DOOR OPENING TRIM COVER RH

HINT
Use the same procedure for the RH side and the LH side Installation.

6. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and the LH side Installation.

7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

11. INSPECT FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Front Passenger Side Knee Airbag Assembly

12. INSPECT SRS WARNING LIGHT

Diagnosis System