Installation

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR

(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(b) Connect the 2 knock control sensor connectors.

2. INSTALL INTAKE MANIFOLD Installation

3. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

4. INSTALL INTAKE AIR SURGE TANK Installation

5. INSTALL NO. 1 AIR CLEANER INLET Installation

6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

8. INSTALL AIR CLEANER INLET ASSEMBLY Installation

9. ADD ENGINE COOLANT Testing and Inspection

10. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

11. CHECK FOR FUEL LEAKS Fuel System

12. INSTALL FRONT SUSPENSION UPPER CENTER BRACE Installation

13. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

14. INSTALL ENGINE ROOM SIDE COVER LH Installation

15. INSTALL ENGINE ROOM SIDE COVER RH Installation

16. INSTALL COOL AIR INTAKE DUCT SEAL Installation

17. INSTALL ENGINE UNDER COVER RH

18. INSTALL ENGINE UNDER COVER LH