Installation

NAVIGATION / MULTI INFO DISPLAY: DISPLAY AND NAVIGATION ASSEMBLY: INSTALLATION

1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY Installation

2. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Attach the 8 claws to install the center instrument panel register.





3. INSTALL NO. 2 RADIO BRACKET

(a) Install the No. 2 radio bracket with the 3 bolts.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

4. INSTALL NO. 1 RADIO BRACKET

(a) Install the No. 1 radio bracket with the 3 bolts.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(b) Attach the claw and clamp to install the connector.

5. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY

(a) Connect the connectors.

(b) Insert the display and navigation module display and attach the 7 clips on the backside of the display and navigation module display.





NOTICE:
When inserting the display, do not press the knobs on it.

(c) Install the display and navigation module display with the 4 bolts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation

7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

9. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET Installation

10. INSTALL FRONT UPPER CONSOLE PANEL GARNISH Installation

11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

14. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.