Bar and Link

Removal

1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.

Raise and support the vehicle.

2. CAUTION: Do not use heat to loosen a seized wheel nut. Heat can damage the wheel and the wheel bearings.

Remove the tire and wheel assembly.





3. Remove the front stabilizer bar link nut from the front suspension lower arms.





4. Remove the LH and RH front stabilizer bar bolts.





5. Remove the LH and RH front stabilizer bar links.





6. Remove the front stabilizer bar.
1 Remove the four bolts.
2 Remove the front stabilizer bar.
3 Remove the lower suspension arm stabilizer bar insulators.

Installation








1. To install, reverse the removal procedure.