LH, Upper - Instrument Panel

Instrument Panel - Upper, LH

Removal and Installation

1. Remove the center instrument panel finish panel. For additional information, refer to Instrument Panel Finish Panel - Center Instrument Panel Finish Panel - Center.

2. Remove the LH A-pillar trim panel.

3. Remove the steering column opening trim panel in the following sequence.

1. Remove the 2 screws.

2. Pull the panel toward the rear of the vehicle releasing the retaining clips.

3. Disconnect the wire harness pushpin retainer and the electrical connector.

4. Press the 2 in-vehicle temperature sensor and aspirator hose assembly lock tabs inward releasing from the cover.

4. Remove the LH instrument panel finish panel.
- Pull rearward releasing the 3 retaining clips.

5. Remove LH instrument panel upper section in the following sequence.

1. Remove the 4 LH instrument panel upper section screws.

2. Pull rearward releasing the 17 retaining clips.

6. To install, reverse the removal procedure.
- To install, make sure to align the retaining clips to the adjacent retaining clip holes.