Seat Position Sensor: Service and Repair

Seat Position Sensor

NOTE: Power seat shown, manual similar.







NOTE:
- The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
- The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Move the driver seat to the full forward and highest position.
2. Change to Ignition Off. Wait 1 minute.
3. Remove the seat position sensor and bracket bolt.
4. Unhook the seat position sensor and bracket from the seat track cross brace.
5. Disconnect the electrical connector and remove the seat position sensor and bracket.
6. To install, reverse the removal procedure.
7. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion.