Compressor

FS-6 SIX CYLINDER COMPRESSOR

Fig. 41 Motorcraft FS-6 six cylinder compressor removal:

Electronic Automatic Temperature Control System
1. Discharge refrigerant from system.
2. Discharge compressor clutch wires from field coil connector on compressor.
3. Disconnect discharge and suction hoses from compressor manifolds. Cap refrigerant lines and compressor manifolds to prevent contamination.
4. Remove three bolts securing front of compressor to power steering pump support and compressor brace.
5. Remove two bolts securing rear compressor brace to power steering pump support.
6. Remove compressor and rear brace, Fig. 41, as an assembly from vehicle.
7. Reverse procedure to install.