Instrument Cluster - Finish Panel

REMOVAL
1. Disconnect battery ground cable.
2. Set parking brake and turn ignition switch to OFF and move shift control selector lever down to low gear position.
3. Tilt steering column tube down as far as possible.
4. Remove RH and LH finish (shelf) mouldings by pulling up to unsnap clips. Disconnect electrical connections.
5. Remove five screws on bottom of cluster trim panel.
6. Unsnap cluster trim panel along the top and sides and remove trim panel from instrument panel.
7. Disconnect the two electrical connectors from the back of cluster trim panel.

INSTALLATION
1. To install, reverse Removal procedure.