DL3 - Check PFE/DPFE Circuit Continuity
- Key "OFF".
- Pressure Feedback EGR (PFE) / Differential Pressure Feedback EGR (DPFE) sensor disconnected.
- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.
- Install breakout box, leave PCM disconnected.
- Measure resistance between PFE/DPFE circuit at the PFE/DPFE sensor vehicle harness connector and test pin 27 at the breakout box.
- Is resistance less than 5.0 ohms?
Yes -- Go to DL4. DL4 - Check PFE/DPFE Circuit For Shorts to Ground and SIG RTN
No -- Service open circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)