X60 - No A/C Cutoff: Check WAC Circuit Continuity

- Key "OFF".

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Disconnect Constant Control Relay Module (CCRM).

- Measure resistance between test pin 54 at the breakout box and Pin 22 at the CCRM vehicle harness connector.

- Is resistance less than 5.0 ohms?

Yes -- Go to X61. X61 - Check WAC Circuit For Shorts to Power

No -- Service open in Wide Open Throttle A/C Cut-Off (WAC) circuit. Remove breakout box. Reconnect all components. Re-evaluate symptom.