Glossary Of Terms Used In Pinpoint Tests
Air Bag SimulatorRotunda Air Bag Simulator 105-00010 or equivalent is
Disconnect Component
Disconnect Component means disconnect component connector and vehicle harness connector. It does not mean remove component. Also, a disconnected part should not be reconnected unless instructed to do so.
Deactivate System
Deactivate System means to perform the Deactivation Procedure.
Prove Out System
Prove OUT System means to turn the ignition switch from OFF to RUN and visually monitor the AIR BAG indicator. The AIR BAG indicator will light continuously for approximately six seconds and then turn off. If an air bag system fault is present, the indicator will either fail to light, remain lit continuously, or flash. The flashing may not occur until approximately 30 seconds after the ignition switch has been turned from OFF to RUN. This is the time required for the air bag diagnostic monitor to complete testing of the air bag system. If the AIR BAG indicator is inoperative and an air bag system fault exists, a tone will sound in a pattern of five sets of five beeps. If this occurs, the AIR BAG indicator will need to be serviced before further diagnosis.
Reactivate System
Reactivate System means to perform the Reactivation Procedure.
WARNING: When the system is reactivated, the air bag simulators must be removed and the air bags reconnected.
Reconnect System
Reconnect System means to reconnect all system components.
Replace Component
Replace Component means to remove the existing component and replace it with an authorized replacement part obtained from Ford Parts and Service Division.
CAUTION: Also, the replacement component should be installed on vehicle and all necessary electrical connections should be completed.
Verify System
Verify System means to prove out system with air bag simulator in place of the air bags.