Rear Seat Safety Belts
Tools RequiredSeat Belt Bolt Bit T77L-2100-A
NOTE: Seat Belt Bolt Bit T77L-2100-A should be used for safety belt bolt removal and installation.
REMOVAL
1. Remove rear seat cushion.
2. Remove rear seat back. On vehicles equipped with head restraints, ensure the web front safety belt guide is opened.
3. Remove cable and buckle assembly anchor plate nuts and remove cable and buckle assembly.
4. Remove upper and lower quarter trim panels.
5. Remove rear safety belt anchor-to-sill bolt.
6. Snap out rear safety belt opening bezel in package tray trim panel.
7. Remove rear stoplamp assembly.
8. Remove package tray trim panel.
9. Remove rear safety belt retractor and tongue anchor bolt and rear safety belt retractor and tongue screw.
10. Remove anchor plate end of rear safety belt through the opening in the quarter trim panel and the package package tray trim panel.
11. Remove outboard rear safety belt and buckle from the vehicle.
12. Repeat procedure on opposite side.
INSTALLATION
1. To install, reverse Removal procedure.