Part 2

47. Remove the LH front strut cover.






48. Disconnect the vacuum line from the secondary air injection solenoid.

49. Relieve fuel system pressure.






50. Using Disconnect Tools D87L-9280-A and D87L-9280-B disconnect the fuel lines.

51. Remove the power steering reservoir.






52. Disconnect the 42-pin connector.






53. Disconnect the 16-pin connector and position the harness aside.






54. Disconnect the coolant return hose from the coolant reservoir.






55. Disconnect the ground wire and four-pin connector.






56. Disconnect the battery junction box (BJB) from the bracket.






57. Disconnect the positive battery cable and fusible link from the BJB. Position the BJB aside.






58. Disconnect the locators and position the harness aside.






59. Disconnect the locators and position the harness aside.






60. Remove the BJB bracket.






61. Remove the nut and position the oil level indicator tube aside.

62. Install the LH lifting bracket D93P-6001-A2.






63. Remove the master cylinder retaining nuts and position the wire harness and master cylinder out of the way.






64. Remove the upper radiator hose.






65. Disconnect and position aside the cooling fan harness.






66. Remove the cooling fan assembly.

- Remove the bolts.
- Remove cooling fan assembly.






67. Disconnect the transmission cooler lines.






68. Using Spring Lock Coupling Disconnect Tool T81P-19623-G2, disconnect the A/C manifold from the condenser.






69. Using Spring Lock Coupling Disconnect Tool T81P-19623-G2, disconnect the A/C manifold from the compressor.






70. Disconnect the A/C pressure cut-out switch.






71. Remove the A/C line.






72. Using Spring Lock Coupling Disconnect Tool T85L-19623-A, disconnect the A/C suction line from the compressor.

73. Disconnect the condenser to evaporator core A/C line from the condenser.






74. Remove the radiator.

- Remove the bolts.
- Remove the radiator retaining brackets.
- Lift and remove the radiator.






75. Disconnect the coolant reservoir supply hose.






76. Remove the lower radiator hose.






77. Disconnect the heater hoses from the heater tubes and position them out of the way.






78. Disconnect the evaporative emission hose.






79. Disconnect the chassis vacuum connector.






80. Remove the upper condenser core mounting brackets and remove the condenser core.

- Remove the bolts.
- Remove the A/C condenser core mounting brackets.
- Remove the A/C condenser core.






81. Remove the LH instrument panel insulator screws.






82. Disconnect the lamp and remove the instrument panel insulator.






83. Remove the instrument panel steering column cover screws and position the instrument panel steering column cover aside.






84. Remove the instrument panel reinforcement.






85. Remove the A/C duct.






86. Disconnect the steering column lower yoke.

- Remove and discard the pinch bolt.
- Slide the intermediate shaft into the lower steering shaft.






87. While supporting the steering column, remove the steering column nuts.






88. Disconnect the connectors.

89. Remove the steering column.

90. Remove the coupling shaft.

91. Raise the vehicle on the hoist.






92. Remove the steering coupling from the steering gear.






93. Using Oxygen Sensor Wrench T94P-9472-A remove the LH upper heated oxygen sensor.

94. Remove the studs from the LH exhaust manifold.






95. Loosen the transmission mount nuts.

96. Lower the vehicle.

97. Support the transmission with a floor jack.

98. Remove the upper two transmission-to-engine bolts.

99. Using a suitable lifting device and Spreader Bar D93P-6001-A3, remove the engine.