With Automatic Transmission

Worldwide Diagnostic System (WDS):

SPECIAL SERVICE TOOL(S)

REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the cabin air filter and plenum. For additional information, refer to Heating and Air Conditioning.







3. Loosen the bolts and disconnect the Powertrain Control Module (PCM) harness connectors.







4. Remove the instrument panel finish panel.







5. Release the assist cable from the glove compartment.







6. Lower the glove compartment.
1 Release the tabs.
2 Lower the glove compartment.







7. If equipped with a compact disc changer, remove the glove compartment inner panel.
1 Remove the screw.
2 Remove the panel.







8. Remove the glove compartment instrument panel finish panel.
1 Remove the screws.
2 Remove the panel.







9. Remove the PCM bracket bolts and bracket.







10. Remove the PCM.

INSTALLATION







1. Install the PCM into the bracket.







2. Install the PCM into the vehicle through the glove box and install the bolts.







3. Install the glove compartment instrument panel finish panel.
1 Position the panel.
2 Install the screws.







4. If equipped with a compact disc changer, install the glove compartment inner panel.
1 Position the panel.
2 Install the screws.







5. Raise the glove compartment.
1 Raise the glove compartment.
2 Position the stop tabs.







6. Connect the assist cable to the glove compartment.







7. Install the instrument panel finish panel.







8. Connect the PCM harness connectors and tighten the bolts.
9. Install the cabin air filter and plenum. For additional information, refer to Heating and Air Conditioning.
10. Connect the battery ground cable.
11. Connect the scan tool.
12. Select ICM.
13. Select ENTER SECURITY ACCESS. Wait 10 minutes for security access to be granted.
14. Select PARAMETER RESET.
15. Disconnect the scan tool.
16. Place ignition key in the OFF position.
17. Place ignition key in the RUN position.
18. Remove the ignition key.