Sensor, Front
Removal and Installation1. Raise and support the vehicle.
2. Position the inner splash shield aside.
1 Remove the pin-type retainers.
2 Position the inner splash shield aside.
3. Disconnect the anti-lock brake sensor electrical connector.
4. Remove the anti-lock brake sensor harness from the brake hose clips.
5. Remove the anti-lock brake sensor.
1 Remove the anti-lock brake sensor clip.
2 Remove the anti-lock brake sensor.
6. Note: Make sure the anti-lock brake sensor is fully seated before installation of the new clip.
To install, reverse the removal procedure.
- Apply a 2.5 mm (0.1 inch) bead of RTV Silicone Sealant F5TZ-19G204-AB meeting Ford specification NAVSTR Seater to the outside diameter of the anti-lock brake sensor.