Floor Duct Door Actuator

REMOVAL AND INSTALLATION
1. Disconnect the battery. Refer to Battery.
2. Remove the driver side instrument panel insulator.
3. Remove the LH floor duct.







4. Remove the actuator.
1 Disconnect the connector.
2 Remove the three screws and remove the actuator.







5. To install, reverse the removal procedure.
- If reinstalling an actuator removed from the vehicle, align the arrow (1) on the actuator housing with the line on the actuator coupling (2).

NOTE: New door actuator assemblies are shipped with the actuator in the mid-position. If reinstalling an actuator removed from the vehicle, use jumper wires to electrically drive the actuator to the mid-position to assist in assembly.