Timing Gear
| Crankshaft Pulley Bolt | Stage 1 | 80 Nm (59 ft. lbs.) |
| Stage 2 | Loosen bolt 2 complete turns | |
| Stage 3 | 50 Nm (37 ft. lbs.) | |
| Stage 4 | Additional 90 degrees | |
| LH Exhaust Camshaft Sprocket Special tool 303-532 required. | Stage 1 | 20 Nm (15 ft. lbs.) |
| Stage 2 | Additional 90 degrees | |
| RH Exhaust Camshaft Sprocket Special tool 303-532 required. The exhaust camshaft sprocket bolt must be fully tightened before tightening the intake camshaft sprocket bolt. | Stage 1 | 20 Nm (15 ft. lbs.) |
| Stage 2 | Additional 90 degrees |