Vehicles Without Side Air Bags

Special Tool(s):

SPECIAL TOOL(S)

REMOVAL

WARNING:
- ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING A SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE AND WHEN HANDLING AN AIRBAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
- AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER AFTERWARDS.
- NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT, WHICH CAN RESULT IN PERSONAL INJURY.

1. Remove the affected seat.







2. Remove the seat position sensor.
1 Disconnect the electrical connector.
2 Remove the seat position sensor bolt and remove the sensor.
3 Remove the magnet assembly bolt.
4 Pull the magnet assembly forward and remove from the pivot.

NOTE:
- Power seat position sensor and magnet is shown; manual seat position sensor is similar.
- Manual seat position sensor is located at the rear lift outboard side of the seat track. It does not use a separate magnet for magnetic pick up.

INSTALLATION

WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS, NOTES AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM DEACTIVATION/REACTIVATION PROCEDURE.







1. Install the seat position sensor.
1 Install the magnet assembly onto the pivot.
2 Install the magnet assembly bolt.
3 Install the seat position sensor and bolt.
4 Connect the seat position sensor electrical connector.

NOTE:
- Power seat position sensor and magnet is shown; manual seat position sensor is similar.
- Manual seat position sensor is located at the rear lift outboard side of the seat track. It does not use a separate magnet for magnetic pick up.

2. Restore the vehicle to operating condition.
1 Install the affected seat.
2 Check the active restraint system for correct operation.