Tire Pressure Module: Service and Repair

Tire Pressure Monitoring System Module





1. Detach the RH C-pillar trim panel and position it aside.
2. Disconnect the electrical connector.
3. Remove the 2 module bolts.
- To install, tighten to 7 Nm (62 inch lbs.).
4. Remove the TPMS module.
5. To install, reverse the removal procedure.
6. Reconfigure the TPMS module. Refer to Information Bus (Module Communications Network).
7. Train the tire pressure sensors. Refer to Sensor Training Component Test. Service and Repair
8. Clear any DTCs and carry out the TPMS module self-test.