Front Seat - 60 Percent

FRONT SEAT - 60 PERCENT

Part 1:

Part 2:

Removal

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the seat to gain access to all seat track-to-floor fasteners.
2. Depower the SRS.
3. Remove the seat track-to-floor rear inner and outer bolt covers.







4. Disconnect the passenger seat safety belt buckle pretensioner electrical connector.
1 Slide and disengage the passenger seat safety belt buckle pretensioner electrical connector locking clip.
2 Push in to release the tab and disconnect the passenger seat safety belt buckle pretensioner electrical connector.

5. Disconnect the safety belt buckle usage detection switch electrical connector.
6. Remove the center safety belt anchor bolt.
7. Remove the seat track-to-floor rear inner and outer bolts.
8. Remove the 2 seat track-to-floor front bolts.

9. NOTE: Removing the 60 percent front seat requires more than one technician.

Remove the 60 percent seat from the vehicle.

Installation

1. NOTE: Installing the 60 percent front seat requires more than one technician.

Position the 60 percent seat in the vehicle.

2. Install the 2 seat track-to-floor front bolts.
- Make sure the safety belt webbing is not twisted prior to installation.
- Tighten to 43 Nm (32 lb-ft).

3. NOTE: Make sure the front center seat belt anchor is located on top of the seat bracket before securing the seat.

Position the front center seat belt anchor and install the seat track-to-floor rear inner and outer bolts.
- Tighten to 43 Nm (32 lb-ft).

4. Position the center safety belt anchor and install the bolt.
- Make sure the safety belt webbing is not twisted prior to installation.
- Tighten to 43 Nm (32 lb-ft).

5. Connect the safety belt buckle usage detection switch electrical connector.







6. Connect the passenger seat safety belt buckle pretensioner electrical connector.
1 Connect the passenger seat safety belt buckle pretensioner electrical connector.
2 Slide and engage the passenger seat safety belt buckle pretensioner electrical connector locking clip.

7. Repower the SRS.
8. Make sure the safety belts and buckles are accessible to the occupants after installation.