Ignition Switch: Service and Repair
Ignition SwitchIgnition Switch:
Removal and Installation
1. Remove the steering wheel.
2. NOTE: Lower tilt release handle to access second screw.
Remove the lower steering column shroud.
^ Remove the screws.
3. NOTE: The screw is located behind the multi-function switch.
Remove the screw and the upper steering column shroud.
4. Remove the bolt, push the release and position the multi-function switch aside.
5. Disconnect the ignition switch electrical connector.
6. Remove the ignition switch.
7. To install, reverse the removal procedure.
^ Make sure that the spring located under the ignition switch is positioned on the steering column lock rod.