Turn Signal Switch: Service and Repair

Steering Column Multifunction Switch
Removal and Installation

Steering Column

Steering Column:

1. Remove the steering wheel.

2. NOTE: Lower tilt release handle to access the second screw.

Remove the lower steering column shroud.
^ Remove the screws.

3. NOTE: The screw is located behind the multi-function switch.

Remove the screw and the upper steering column shroud.





4. Remove the bolt, push the release and raise the switch.

5. NOTE: A small screwdriver will be required to depress the connector release tab on connector number 2.

Remove the multi-function switch.
^ Disconnect the 3 multi-function switch electrical connectors.
^ Remove the switch.
6. To install, reverse the removal procedure.