Front Door Window Regulator
FRONT DOOR WINDOW REGULATORRemoval and Installation
All vehicles
1. Remove the front door trim panel.
2. Remove the screws and the front door speaker.
- Disconnect the electrical connector.
3. Remove the front door weathershield.
Expedition
4. NOTE: Driver side shown, passenger side similar.
Connect the window control switch.
All vehicles
5. Lower the window glass to access the 2 window glass-to-regulator bolts.
Expedition
6. NOTE: Driver side shown, passenger side similar.
Disconnect the window control switch.
All vehicles
7. Remove the window glass-to-regulator bolts and front door window glass.
- To install, tighten to 11 Nm (8 lb-ft).
8. NOTE: Secure the front window glass in the full UP position.
Secure the front window glass with tape to the front door frame.
9. Position the interior door handle aside.
1 Remove the cable conduit fitting from the carrier assembly.
2 Lift upward on the interior door handle retaining bracket and pivot the interior door handle out of the bracket.
3 Remove the cable from the door handle.
10. Release the crash sensor harness pin-type retainers.
11. Position the front door window regulator harness aside.
1 Disconnect the electrical connectors.
2 Release the pin-type retainers.
12. Remove the front window regulator.
1 Loosen the 2 hanger bolts.
2 Remove the front window regulator bolts and front top run channel bolt.
- To install, tighten to 11 Nm (8 lb-ft).
13. To install, reverse the removal procedure.