Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the accessory drive belt.
3. Disconnect the A/C compressor electrical connector.
4. Remove the 3 bolts and position the A/C compressor aside.
- To install, tighten to 25 Nm (18 lb-ft).

5. Disconnect the crankshaft position (CKP) sensor electrical connector.
6. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).
- Lubricate the O-ring seal with clean engine oil prior to installation.

7. To install, reverse the removal procedure.