Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (I know, we said we wouldn't ask any more...but it's important!)

Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Place a drain pan beneath the Output Shaft Speed (OSS) sensor.

3. Remove the OSS sensor.
- Disconnect the OSS electrical connector.

- Remove the OSS bolt.

- Inspect the OSS bore.

4. Inspect the OSS O-ring seal for nicks or cuts, install a new OSS O-ring if necessary.

Installation

1. NOTE: Apply a light coat of petroleum jelly to the O-ring before installation.

Install the OSS sensor.

- Tighten the OSS sensor bolt to 10 Nm (89 lb-in).

- Connect the OSS electrical connector.

2. Check the transmission fluid level and add transmission fluid as necessary.

3. Start the engine and move the selector lever through all gear positions.