Heated Seat Module - Rear

Heated Seat Module - Rear

Removal and Installation

1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear Rear Seat.

2. Release part of the close-out trim cover at the bottom LH side and position aside.

3. Release the bottom LH cushion trim cover J-clip.

4. Disconnect the 2 electrical connectors, remove the scrivet and heated seat module.

5. To install, reverse the removal procedure.

6. Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.

- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.