Transmission Fluid Cooler Tubes - 6F35

Transmission Fluid Cooler Tubes - 6F35









Transmission Fluid Cooler Tubes









Removal

NOTICE: Automatic transmission fluids are not interchangeable. The use of any fluid other than what is recommended for this transaxle will cause transaxle damage.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the upper transmission fluid cooler tube from the radiator.





3. Remove the bolts and the splash shield.





4. Remove the radiator splash shield.

1. Remove the 6 screws.

2. Remove the 4 retainers.





5. Disconnect the lower transmission fluid cooler tube from the radiator.





6. Remove the transmission fluid cooler tube secondary latches.





7. Using the Transmission Cooler Line Disconnect Tool, disconnect the transmission fluid cooler tubes.





8. NOTE: When removing the transmission fluid cooler tubes from the retainers, do not remove the retainers from the shroud.

Release the transmission fluid cooler tube retainers and remove the transmission fluid cooler tubes from the retainers.





9. Remove the transmission fluid cooler tube retainer and remove the transmission fluid cooler tubes from the vehicle.





10. Remove the Air Cleaner (ACL) and the outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

11. Remove the battery and battery tray. For additional information, refer to Battery.

12. Open the transmission fluid cooler tube retainers.





13. Remove the 2 transmission fluid cooler tube secondary latches.





14. Using the Transmission Cooler Line Disconnect Tool, disconnect and remove the transmission fluid cooler tubes from the transaxle.





Installation

1. Install the transmission fluid cooler tubes in the transaxle by inserting the tube into the fitting until a click is heard/felt. Pull back to confirm connection is secure and position them in the retainer mounted on the main control cover studbolts.





2. Install the 2 transmission fluid cooler tube secondary latches.





3. Position the transmission fluid cooler tubes in the retainers and close the 2 transmission fluid cooler tube retainers.





4. Install the battery and battery tray. For additional information, refer to Battery.

5. Install the ACL and the outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

6. Position the transmission fluid cooler tubes in place in the vehicle and install the retainer.





7. Position the transmission fluid cooler tubes in the retainers and close the retainers.





8. Connect the transmission fluid cooler tubes by inserting the tube into the fitting until a click is heard/felt. Pull back to confirm that the connection is secure.





9. Install the transmission fluid cooler tube secondary latches.





10. Install the lower transmission fluid cooler tube in the radiator.
- Tighten to 20 Nm (177 lb-in).





11. Install the radiator splash shield

1. Install the 6 screws.

2. Install the 4 retainers.





12. If equipped, install the bolts and the splash shield.





13. Install the upper transmission fluid cooler tube in the radiator.
- Tighten to 20 Nm (177 lb-in).





14. Fill the transmission fluid level to the correct level. For additional information, refer to Automatic Transmission/Transaxle &/or Transmission Control Systems.