Inspection And Verification

Blind Spot Monitoring

Inspection and Verification

1. Verify the customer concern.

2. Visually inspect for obvious signs of mechanical and electrical damage.

Visual Inspection Chart





3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

4. NOTE: Make sure to use the latest scan tool software release.

If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

5. NOTE: The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.

If the scan tool does not communicate with the vehicle:

- verify the ignition key is in the ON position.

- The air bag warning indicator prove-out confirms ignition ON (other indicators may NOT prove ignition is ON) confirms ignition ON. If ignition does not turn ON, refer to Steering Column Switches Testing and Inspection to diagnose no power in RUN.

- verify the scan tool operation with a known good vehicle.

- Refer to Module Communications Network Testing and Inspection, Inspection and Verification to establish a scan tool session.

6. NOTE: The ignition must be OFF to carry out the RFA module self-test.

Carry out the self-test diagnostics for the Remote Function Actuator (RFA) module, Side Obstacle Detection Control Module - Left (SOD-L) and Side Obstacle Detection Control Module - Right (SOD-R).

7. If the DTCs retrieved are related to the concern, go to DTC Charts. For all other DTCs, refer to the Diagnostic Trouble Code (DTC) Chart in Multifunction Electronic Modules Diagnostic Trouble Code (DTC) Chart. Blind Spot Monitoring

8. If no DTCs related to the concern are retrieved, GO to Symptom Chart. Blind Spot Monitoring