Console - Short, Floor

Console - Short, Floor









Removal and Installation

NOTICE: When prying on a component, a non-marring tool must be used or damage to the component may occur.

1. Place the selector lever in the NEUTRAL position.

2. Remove the floor console rear control panel in the following sequence.

1. With a non-marring tool, pry the panel rearward to release the retaining clips.

2. Disconnect the 2 electrical connectors.

3. Remove the front cup holder in the following sequence.

1. With a non-marring tool, lift the cup holder upward, releasing the retaining clips.

2. Disconnect the electrical connector.

4. Remove the LH and RH floor console finish mouldings in the following sequence.

1. With a non-marring tool, release the rear retaining clips from the floor console by prying the mouldings upward.

2. With a non-marring tool, release the front retaining clips from the instrument panel by prying the mouldings toward the rear of the vehicle.

3. Lower the moulding downward from the upper instrument panel sections.

5. With a non-marring tool, detach the selector lever knob bezel.





6. NOTE: LH side shown, RH side similar.

Remove the selector lever knob.

- Remove the 2 selector lever knob screws.





7. Remove the selector lever trim panel in the following sequence.

1. Remove 2 selector lever screws.

2. With a non-marring tool, pry the rear portion of the panel upward, releasing the rear retaining clips.

3. Pull the panel rearward, releasing the rear retaining clips from the Audio Control Module (ACM) finish panel.

4. Disconnect the electrical connector.

8. NOTE: Do not remove the LH and RH floor console front side trim panels.

With a non-marring tool, detach the LH and RH floor console front side trim panels.

- Pull the panels away from the floor console releasing the retaining clips.

9. Position the front seats forward.

10. Remove the 2 rear floor console bolts.
- To install, tighten to 7 Nm (62 lb-in).

11. Disconnect the front section LH in-line electrical connector.

12. Position the front seats rearward.

13. Remove the 2 front and 2 center floor console bolts.
- To install, tighten to 7 Nm (62 lb-in).

14. Attach the LH and RH floor console front side trim panels.

15. Remove the 2 floor console-to-instrument panel screws.

16. Remove the front storage compartment mat and access panel.

17. Detach the wire harness pin-type retainer from the floor console.

18. Disconnect the front section front in-line electrical connector.

19. Disconnect the selector lever cable from the selector lever.





20. Remove the selector cable from the selector lever cable bracket.
- Release the 2 selector cable retaining tabs and pull the selector lever cable upwards.





21. Remove the floor console front section in the following sequence.

1. Pull the floor console rearward to release the retaining clips from the instrument panel.

2. Remove through the LR door opening.

22. To install, reverse the removal procedure.
- To install, make sure to align the retaining clips to the adjacent retaining clip holes.