Heated Seat Module - Second Row

Heated Seat Module - Second Row

Removal and Installation

NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row Seat - Exploded View, Second Row.

1. On the second row 40 percent seat cushion, separate the strut and disengage the cushion cover J-clip.
- At installation, make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion cover and accessible for use after installation.





2. Disengage the cushion cover J-clip at the rear attached to the cushion frame and open the flap.

3. Disconnect the electrical connectors, remove the screw and the heated seat module.

4. To install, reverse the removal procedure.