Seat - Second Row

Seat - Second Row

60/40 Bench Seat









40 Percent Bench or Bucket Seat

NOTE: LH seat shown, RH similar.









Removal

NOTE: Returning the seat from the E-Z entry position to the load floor position will latch the inboard latch foot.

The inboard latch foot must latch before the seat backrest will return to the upright position.

Returning the seat backrest to the upright position will latch the outboard latch foot.

1. Using the recliner handle, fold the affected seat up to the E-Z entry position.

2. If equipped, disconnect the seat electrical connector(s).

3. Remove the 2 riser/seat track-to-floor pan bolts and 2 riser/seat track-to-floor pan nuts for the affected seat.

4. Remove the seat.

Installation

RH bucket or 40 percent bench seat

1. Position the seat in the vehicle and install the retainers.

1. Install the riser/seat track-to-floor pan rear inboard nut.
- Tighten to 48 Nm (35 lb-ft).

2. Install the riser/seat track-to-floor pan rear outboard nut.
- Tighten to 48 Nm (35 lb-ft).

3. Install the riser/seat track-to-floor pan front outboard bolt.
- Tighten to 48 Nm (35 lb-ft).

4. Install the riser/seat track-to-floor pan front inboard bolt.
- Tighten to 48 Nm (35 lb-ft).





LH bucket or 60 percent seat

2. Position the seat in the vehicle and install the retainers.

1. Install the riser/seat track-to-floor pan rear inboard nut.
- Tighten to 48 Nm (35 lb-ft).

2. Install the riser/seat track-to-floor pan rear outboard nut.
- Tighten to 48 Nm (35 lb-ft).

3. Install the riser/seat track-to-floor pan front outboard bolt.
- Tighten to 48 Nm (35 lb-ft).

4. Install the riser/seat track-to-floor pan front inboard bolt.
- Tighten to 48 Nm (35 lb-ft).





All seats

3. If equipped, connect the electrical connector(s).