Headlamp Control Module (HCM)

Headlamp Control Module (HCM)

NOTE: The front bumper cover is shown removed for clarity.









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the 4 screws and position aside the fender splash shield.





3. Disconnect the HCM electrical connector.

4. Remove the 2 bolts and the HCM.
- To install, tighten to 8 Nm (71 lb-in).

5. To install, reverse the removal procedure.