Door Glass Run Retainer - Rear

Door Glass Run Retainer - Rear

Removal and Installation

Front and Rear Retainer

NOTE: The window motor must be de-initialized, then initialized whenever the window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Position the rear door glass to the full UP position.

Front Retainer

2. Remove the rear door speaker. For additional information, refer to Information and Entertainment Systems Speaker - Door.

3. Position aside the water shield.

4. Remove the 2 door glass run retainer bolts.
- To install, tighten to 8 Nm (71 lb-in).





Rear Retainer

5. Remove the rear door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

6. Position aside the water shield.

7. Remove the 2 door glass run retainer fasteners.
- To install, tighten to 8 Nm (71 lb-in).





Front and Rear Retainer

8. Remove the glass run retainer through the large opening in the door.

9. To install, reverse the removal procedure.
- De-initialize, then initialize the window regulator motor. For additional information, refer to Window Motor Initialization Service and Repair.