Window Glass - Fixed, Rear Door

Window Glass - Fixed, Rear Door

Removal and Installation

NOTE: The door glass run and bracket is part of the rear window fixed glass assembly and cannot be serviced separately.

NOTE: The window motor must be de-initialized, then initialized whenever the window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the window control switch. For additional information, refer to Window Control Switch Service and Repair.

2. Remove the rear door trim panel and window garnish moulding. For additional information, refer to Interior Trim and Ornamentation D-Pillar Trim Panel.

3. Remove the water shield.

4. Temporarily install the window control switch and lower the window glass to access the glass-to-regulator clamp locking tab.

5. Using a suitable tool, push the glass-to-regulator clamp locking tab inward then gently lift the glass upward slightly to release the glass from the regulator clamp.
- To install, gently push the glass down into the clamp until an audible click is heard, indicating the glass has seated correctly into the glass clamp.

6. While holding the door glass, carefully lower the regulator to the full down position and allow the door glass to rest loosely on top of the regulator.

7. Remove the 2 fasteners and the rear door glass run retainer.
- To install, tighten to 8 Nm (71 lb-in).





8. Remove the interior door glass weatherstrip.

9. Remove the top run corner trim panel.
- Pull outward to release the retaining clip.





10. Remove the rear door window glass top run screw.
- To install, tighten to 5 Nm (44 lb-in).





11. Remove tape and then remove the rear door fixed window glass bolt.
- To install, tighten to 8 Nm (71 lb-in).





12. NOTE: The door glass run and bracket is part of the rear window fixed glass assembly and cannot be serviced separately.

Position aside the top run and remove the rear door fixed window glass.

- Tip the front of the fixed glass assembly down and pull the assembly out through the top outboard side of the door.





13. To install, reverse the removal procedure.
- De-initialize, then initialize the window regulator motor. For additional information, refer to Window Motor Initialization Service and Repair.