Console - Floor

Console - Floor

Edge Floor Console Finish Panels










Edge Floor Console Trim Panels










MKX Floor Console Finish Panels










MKX Floor Console Trim Panels










Floor Console Fasteners

NOTE: MKX shown, Edge similar.









All vehicles

1. Apply the parking brake.

2. Position the selector lever to NEUTRAL.

3. Position the front seats to the full rearward and downward positions and fully recline the seat backs.

4. NOTE: MKX shown, Edge similar.
Remove the LH and RH floor console finish mouldings.






MKX

5. Remove the floor console H-panel.





6. Pull the LH and RH lower floor console side trim panels outward to release the retaining clips separating the lower side trim panel from the console and the upper side trim panel.

7. NOTE: Right side shown, left side similar.
Remove the LH upper floor console side trim panel.






8. Remove the upper RH floor console side trim panel. Disconnect the power point electrical connector.

9. NOTICE: Damage to the floor console rear trim panels may occur if cardboard is not used to remove the lower floor console side trim panels.

NOTE: The RH lower floor console side panel shown, LH lower floor console side trim panel similar.
Position a piece of cardboard between the LH and RH lower floor console side trim panels and the floor console.






10. Remove the RH and LH lower floor console side trim panel and cardboard simultaneously.

11. Remove the 8 selector lever trim panel screws.





12. Disconnect the 4 electrical connectors.

13. Disengage the selector lever boot tabs from the trim panel.

14. Remove the selector lever trim panel.





Edge

15. Remove the 4 screws and disconnect the floor console electrical connector.





16. Disengage the selector lever boot tabs from the selector lever trim panel.

17. Remove the selector lever trim panel.

18. Pull the LH and RH floor console side trim panels outward to release the retaining clips separating the side trim panels from the console.

19. NOTICE: Damage to the floor console rear trim panels may occur if cardboard is not used to remove the lower floor console side trim panels.

NOTE: The RH floor console side trim panel shown, LH floor console side trim panel similar.
Position a piece of cardboard between the LH and RH floor console side trim panels and the floor console.






20. Remove the LH and RH floor console side trim panel and cardboard simultaneously.

21. Remove the 6 screws, disconnect the electrical connector.





22. NOTE: If equipped, the ambient light will be located at front of selector lever trim panel.
Remove the ambient light from the floor console.

1. Detach the ambient wiring harness from the floor console.

2. Rotate the ambient light counterclockwise and remove the ambient light from the floor console.






23. Remove the floor console finish panel.

All vehicles

24. Disconnect the selector lever cable from the selector lever.





25. Remove the selector cable from the selector lever cable bracket.
- Release the 2 selector cable retaining tabs and pull the selector lever upward.






26. Disconnect the 3 electrical connectors and the 1 pin type retainers from the console.





27. Remove the 8 floor console bolts.
- Pull the console rearward from the instrument panel then upward to remove.

- To install, tighten to 8 Nm (71 lb-in).






28. To install, reverse the removal procedure.