Pinpoint Test H: DTC U3000:44,45,46,48,49 Or 4A

Blind Spot Monitoring

Pinpoint Test H: DTC U3000:44,45,46,48,49 Or 4A

Normal Operation

On each ignition cycle, the Side Obstacle Detection Control Module - Right (SOD-R) and Side Obstacle Detection Control Module - Left (SOD-L) run a self-diagnostic check during which the exterior mirror BLIS(TM) (Blind Spot Information System) /CTA (Cross Traffic Alert) LEDs illuminate for 3 seconds then turn off indicating the system is operational. If a DTC fault is present, a system fault message is displayed in the message center.





This pinpoint test is intended to diagnose the following:

- SOD-R (Side Obstacle Detection Control Module - Right)

- SOD-L (Side Obstacle Detection Control Module - Left)

PINPOINT TEST H : DTC U3000:44,45,46,48,49 OR 4A

H1 CHECK THE SOD-R (Side Obstacle Detection Control Module - Right) and SOD-L (Side Obstacle Detection Control Module - Left) FOR DTCs

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: SOD-R (Side Obstacle Detection Control Module - Right) and SOD-L (Side Obstacle Detection Control Module - Left) Module Self-Test.

- Clear the DTCs.

- Ignition OFF.

- Wait 5 seconds

- Ignition ON.

- Repeat the SOD-R (Side Obstacle Detection Control Module - Right) and SOD-L (Side Obstacle Detection Control Module - Left) module self-test.

Are any U3000 DTCs present?

Yes
INSTALL a new SOD-R (Side Obstacle Detection Control Module - Right) or SOD-L (Side Obstacle Detection Control Module - Left). REFER to Side Obstacle Detection (SOD) Module . TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by an intermittent problem.