Hazard Warning Switch: Service and Repair

HAZARD FLASHER SWITCH

Removal and Installation

1. Disconnect the battery ground cable.

NOTE: If equipped with an automatic transaxle, apply the parking brake and position the transaxle range selector lever to the 1 position.




2. Position the instrument panel center finish panel rearward.
1. Remove the screws.
2. Position the instrument cluster finish panel rearward.




3. Remove the hazard flasher switch.
1. Disconnect electrical connector.
2. Remove the screws.
3. Remove the hazard flasher switch.

4. To install, reverse the removal procedure.