With NGS V9.0 Card - PATS Type B

NOTE:

^ Performing this procedure will erase all keys from vehicle memory.

^ If customer's remaining keys are not available with vehicle, instruct customer to refer to Owner's Manual Guide "Programming Spare Keys" to program additional keys.

^ Requires two (2) keys with correct key cut.

1. Using v9.0 NGS, connect to DLC and turn key to ON position.

2. Select the following in the NGS menu:

a. Vehicle/engine

b. Diagnostic Data Link

c. PATS

d. Function Tests

e. Enter Security Access (10 minute delay)

f. Ignition Key Code Erase

3. Turn ignition key OFF and disconnect DLC. Wait 10 seconds before beginning next step.

4. Cycle Key1 in ignition to ON (leave in ON position for at least 3 seconds).

5. Cycle Key2 in ignition to ON (leave in ON position for at least 3 seconds).

6. Program additional keys using Spare Key Programming Procedure.