Pinpoint Test 2

PINPOINT TEST 2: ONE TURN SIGNAL/HAZARD LAMP IS INOPERATIVE/ALWAYS ON

Normal Operation
When the multifunction switch is placed in the LH or RH TURN position, the multifunction switch routes the voltage to the LH or RH front turn lamps through circuits (GY/Y) and (V/W), respectively. The multifunction switch also routes the voltage to the LH or RH rear lamps through the existing stoplamp circuitry. Ground for the indicator flasher relay is provided through circuit (B/Y).

This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Multifunction switch

CAUTION: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

Step 1-Step 3:

Step 4-Step 5:

Multifunction Switch, Turn Portion Component Test:

Multifunction Switch, Turn Portion Component Test (Part 1):