P Range Switch

P RANGE SWITCH

Inspection of Continuity





1. Disconnect the negative battery cable.
2. Remove the screws and remove the selector lever knob.
3. Remove the front console.
4. Remove the indicator panel.
5. Disconnect the P range switch connector.









6. Check continuity between the terminals.
7. If not as specified, replace the P range switch.





8. Adjust the indicator panel. Install the screws in the order shown in the figure.
9. Install the front console.
10. Install the selector lever knob and tighten the screws.

Tightening torque: 1.5-2.9 N.m (15-30 cm-kg, 13-26 in-lb)

11. Connect the negative battery cable.
12. Check for correct operation of the shift-lock system.