Throttle Full Close Switch: Adjustments

Throttle Sensor Terminal Identification:

1. Disconnect throttle sensor connector from throttle sensor.
2. Connect an ohmmeter between terminals "C" and "D".

Continuity Check:

3. Check for continuity between terminals with a feeler gauge inserted between throttle stop screw and throttle valve lever. With a 0.5 mm (0.02 in) gauge inserted, there should be continuity between terminals. With a 0.7 mm (0.028 in) gauge inserted, there should be no continuity between terminals.

Throttle Sensor:

4. If not within specifications, loosen screws and rotate throttle sensor to adjust.
5. Tighten screws and seal them with white paint. After checking and adjusting the sensor, connect sensor connector.